2E1 to 2 Ethernet Interface Converter
2E1 to 2 Ethernet Interface Converter
Welcome to a Biomedical Battery specialist of the Fukuda Battery
2 E1 to 2 Ethernet Interface Converter is also called 2 E1 to 2 Ethernet protocol converter with battery like Fukuda FX-2201 Battery, Fukuda FX-3010 Battery, Fukuda FCP-4610 Battery, Fukuda FCP-2155 Battery, Fukuda 8/HRY-4/3AFD Battery, Fukuda FCP-7102 Battery, Fukuda FX-7100 Battery, Fukuda 8PH-4/3A3700-H-J18 Battery, Fukuda FX-4610 Battery, Fukuda FCP-4010 Battery, Medtronic M240 Battery, Primedic DM30 Battery. The E1 to 4 10/100Base-T serial interface converter used back multiplexing technology, transfer 10M/100M Ethernet data by using multi E1 channels. Realize convert between E1 channel and Ethernet interface. It can transmit signal of E1 channel to RJ48 interface point to point, realize the connection of E1 channel and Ethernet. It is different from normal bridge, supporting E1 channel customized configuration, auto detecting the number of E1 channels and use the available E1, allow some limiting transfer delay between different E1 channels. Single line speed is 1968Kbits/s, 4 channels can up to 7872Kbits/s. It can connect with Ethernet switch or hub when in 10/100Mbps full/half duplex mode, make use of mass E1 resource in telecommunication networks to expend the transfer distance and application field of Ethernet, is a suitable solution for broadband switch in of Ethernet. It can used in fields such as connecting LANs, connecting end offices, VOD, remote monitor, E1 interface of switches, etc.
2 E1 to 2 Ethernet Interface Converter Features:
♦ Realize transparent transfer ethernet data in x to xE1 channels.
♦ 10/100M Ethernet, full/half duplex self adapt, support VLAN.
♦ Ethernet support AUTO-MDIX( cross over and straight through self adapt) setting CRC alarm limitation to auto isolate lines with low transfer quality, single direction.
When one direction error rate over limitation, disconnect only one direction, the other is not affected. Unbalance in two directions.
♦ Allow xE1 channels up to 10ms transfer delay. When the delay over the limitation, can stop transfer automatically.
♦ Having 2 loop back functions: E1 local loop, E1 external loop.
♦ Support dynamic ethernet MAC address (4096), having local address filter function.
♦ E1 interface compatible with ITU-T G.703, and G.823. Signaling slot not supported.
♦ E1 interface having internal clock resume circuit and HDB3 codec circuit.
♦ Support E1 channel hot plug, and auto-detect available E1 channels not pause thetransmission.
♦ Supporting x to xE1 channels customized configuration, auto detect the number of E1 channels and select the available E1 at reset.
♦ Support reset remote system from local system.
♦ Having Ethernet monitor auto reset function.